by Using either Wet & Forget® or Rapid Application® 
(with the new Sniper Nozzle)

 

clean up bricks with Rapid Application

IMPORTANT:

You cannot use regular Wet & Forget 5L (blue) with the Rapid Application Sniper Nozzle. It will NOT work!

  • The active ingredients are the same but the dilutions are different.
  • Coverage of 100-300m2 is exactly the same for both products
  • Common coverage is about 100-150m2 as it is usually used on ‘absorbent’ porous surfaces

 

Clean Your Bricks and Pavers with Rapid Application® (using the new Sniper Nozzle)

  1. Attach your hose, turn to ON and off you go!
  2. No mixing!. No measuring! No mess!
  3. Choose a cool, dry day to apply it.
  4. Saturate the dry surface you are cleaning with the Rapid Application®
  5. NO rain for the first 5 hours - Then, just watch it come cleaner - bit by bit
  6. Only one application! (except in extreme cases of heavy contamination)

                         Clean Your Bricks and pavers with Rapid Application  Sniper Nozzle for Cleaning bricks

          

Clean Your Bricks and Pavers with Wet & Forget®

  1. Mix it up 1 to 5 in your garden sprayer. Choose a cool, dry day to apply it.
  2. Saturate the dry surface you are cleaning with the Wet & Forget
  3. No rain for the first 5hours - Then, just watch it come cleaner - bit by bit
  4. Only one application! (except in extreme cases of heavy contamination)
  5. You can use it safely on ANY exterior surface because there is NO BLEACH in our product
  6. NO BLEACH means an unlimited shelf life
  7. Contains a special surfactant to give a more even dispersal. It also helps product grip onto vertical surfaces

                                          Clean up your bricks, pavers & concrete with Wet & Forget

    Clean up your bricks ,pavers & concrete
Helpful Hints:
  • Total saturation of the surface with this product is essential in order to obtain a good kill of the fungi, algae, lichen, moss & algae which infests these surfaces.
  • Make sure the surface is dry in order to get the best penetration of the growth with the least amount of evaporation.
  • If the surface is particularly bad, another application approximately one month from the first application and then allow the surface to weather naturally and nature will take its course. The growth decomposes while the rain gently removes them from the surface over time.
  • After 1st application use as a maintenance tool. Only re-apply at the first sign of regrowth.